MSGID: 2:240/1120.29 879ff705   
   CHRS: IBMPC 2   
   TZUTC: 0200   
   REPLY: 2:310/31.3@fidonet fd4384ce   
   //Hello Martin,//   
      
   on *09.06.22* at *6:07:00* You wrote in Area *WINPOINT*   
   to *Alan Beck* about *"default zones"*.   
      
    MF> Hello Alan!   
      
    MF> *** Wednesday 08.06.22 at 11:34, Alan Beck wrote to All:   
      
    AB>> The default zones in various spots were set to zone 2.   
      
   As it turns out, the setup program nowadays always sets the default zone to 2.   
   This gives me the creeps as the correct code exists, but is commented out:   
      
     Registry.WriteInteger('Tosser','Zone',2); //Uplink.SysopAddress.Zone   
      
   I wonder why this is so. I will revert this for the next release as I cannot   
   tell why it is so.    
      
   Still, there is IMHO only one default zone setting, which is in the "Tosser   
   Settings" part of the settings dialog. Where else do you think you spotted it?   
      
   Anyway, the default zone setting should not be that important as it is only   
   used in some corner cases and for numbering the outbounds, which is totally   
   internal and doesnt matter.      
      
   Regards,   
   Tim   
      
   --- WinPoint 408.3   
    * Origin: Original WinPoint Origin! (2:240/1120.29)   
   SEEN-BY: 15/0 106/201 124/5016 129/331 153/757 7715 203/0 221/0 1   
   SEEN-BY: 221/6 229/110 111 112 113 317 426 428 470 664 700 240/1120   
   SEEN-BY: 266/512 280/464 5003 5555 282/1038 291/111 292/854 8125 301/1   
   SEEN-BY: 301/113 310/31 317/3 320/219 335/364 341/66 234 371/0 396/45   
   SEEN-BY: 460/58 633/280 712/848 770/1 2452/250 3634/12 5020/1042 5058/104   
   PATH: 240/1120 301/1 280/464 712/848 229/426