MSGID: 2:240/1120.29 3bcd0c80   
   CHRS: IBMPC 2   
   TZUTC: 0100   
   REPLY: 2:280/5555.10 3b432804   
   //Hello Rinaldo,//   
      
   on *25.02.22* at *20:46:58* You wrote in Area *WINPOINT*   
   to *Tim Schattkowsky* about *"test"*.   
      
    RV> Hallo Tim,   
      
    RV> on 25.02.22 at 19:56:49 you wrote in the Area WINPOINT on Rinaldo   
    RV> Visscher one message with   
    RV> Thema "Re: test".   
      
    TS>> Hello Rinaldo,   
      
    TS>> on 25.02.22 at 14:23:13 You wrote in Area WINPOINT to Martin Foster   
    TS>> about "test".   
      
    RV>>>>>>> AREA:WinPoint   
    RV>>>>>>> @MSGID: 2:280/5555.10 37765399   
    RV>>>>>>> @CHRS: IBMPC 2   
    RV>>>>>>> @TZUTC: 0100   
    RV>>>>>>> test   
      
    MF>>>>>> Ack!   
    RV>>>>> ???????? Fonts?   
      
    MF>>>> What??????   
      
    RV>>> My charset was wrong?   
      
    TS>> Probably. Anything outside the selected charset ends up as ?. Have on   
    TS>> the list to display a warning when this will happen so the user can   
    TS>> change the charset. UTF-8 of course always works, but may not display   
    TS>> properly on all clients   
      
    RV> Changed, is it correct now?   
      
   Still using IBMPC. What language where you trying to write? The whole charset   
   topic is slightly more complicated ...   
      
   However, if you wish to default to UTF-8 for new messages, you should change   
   this in the prototype area (for new areas) and in the properties for all   
   existing areas.   
      
   Regards,   
   Tim   
      
   --- WinPoint 400.4   
    * Origin: Original WinPoint Origin! (2:240/1120.29)   
   SEEN-BY: 15/0 92/1 106/201 129/331 153/7715 218/700 221/1 6 229/110   
   SEEN-BY: 229/317 426 428 664 700 240/1120 266/512 280/464 282/1038   
   SEEN-BY: 292/854 301/1 113 317/3 320/219 335/364 341/66 371/0 396/45   
   SEEN-BY: 460/58 712/848 2452/250 3634/12 5020/1042 5058/104   
   PATH: 240/1120 301/1 229/426