INTL 3:770/1 3:770/3
REPLYADDR invalid@invalid.invalid
REPLYTO 3:770/3.0 UUCP
MSGID: 939de12f
REPLY: 1baf4b77
PID: SoupGate-Win32 v1.05
XPost: sci.electronics.design
"John Larkin" wrote in message
news:d21ibjdvt6odqium3ado62ob1e7sa6n9hc@4ax.com...
>I want to use an Raspberry Pi 400 (the keyboard thing) as the
> dev/debug system for an RP2040 based product.
>
> https://www.amazon.com/Raspberry-Computer-Keyboard-Layout-Kabel/dp/B08QCQVWH2
>
> It has a 40-pin connector on the back. Various sources say that pins 1
This connector?
https://www.pi4j.com/1.3/images/pi4j-rpi-400-pinout.png
> 3 and 5 are either GPIO ports 8 9 and 7 or maybe 2 3 and 4.
>
> Sometimes the pins are labeled WPI and BCM. Wot's that?
>
> https://www.amazon.com/Coolwell-Waveshare-Raspberry-Adapter-Ex
ansion/dp/B08RZCR7S8
If that's just a connector then continuity check it to the above drawing of
the connector on the Pi.
>
> I can fix most mistakes there in software, just by reassigning port
> names. But two pins are critical, the SWDIO and SWCLK debug lines out
> to a Pi Pico or to the 2040 chip.
>
> I suspect that on the Pi 400 pin 18 is GPIO5 = SWDIO and pin 22 is
> GPIO6 = SWCLK.
>
> Is that right? Does that actually work?
>
> I also note that some people also connect the UART tx/rx between the
> Pi400 and a Pico for debugging. Should I do that too? Does it help
> software development?
>
> Thanks!
--- SoupGate-Win32 v1.05
* Origin: Agency HUB, Dunedin - New Zealand | Fido<>Usenet Gateway (3:770/3)
SEEN-BY: 19/38 90/1 105/81 106/201 129/305 153/757 7715 218/700 840
SEEN-BY: 220/70 226/17 30 100 227/114 229/110 111 114 200 206 300
SEEN-BY: 229/317 400 426 428 470 550 616 664 700 266/512 267/800 282/1038
SEEN-BY: 291/111 292/854 310/31 320/219 322/757 342/200 396/45 460/58
SEEN-BY: 633/280 281 412 418 420 509 2744 712/848 770/1 3 100 330
SEEN-BY: 770/340 772/210 220 230 5020/400 5075/35
PATH: 770/3 1 633/280 229/426
|
