INTL 3:770/1 3:770/3   
   REPLYADDR address@is.invalid   
   REPLYTO 3:770/3.0 UUCP   
   MSGID:  ff6d6fcc   
   REPLY:  9285700e   
   PID: SoupGate-Win32 v1.05   
   Joerg,   
      
   > Yes, it is possible for a Raspberry Pi to send a signal to a TV to   
   > switch the HDMI input before shutting down. This can be done using   
   > CEC (Consumer Electronics Control),   
      
   A partial success.  After having installed  the cec-client software I was   
   able to do a scan and switch the TV off (meaning : the TV does respond to   
   CEC commands).   
      
   However, the "as" argument didn't seem to do anything.   
      
   I also tried a few "tx" arguments (found on the Web) with the TV (0.0.0.0)   
   as the target but could not evoke a back-to-tuner-input response either.   
      
   Any idea(s) ?   
      
   Regards,   
   Rudy Wieser   
      
   --- SoupGate-Win32 v1.05   
    * Origin: Agency HUB, Dunedin - New Zealand | Fido<>Usenet Gateway (3:770/3)   
   SEEN-BY: 90/1 105/81 106/201 129/305 153/757 7715 218/700 840 220/70   
   SEEN-BY: 221/1 6 242 360 226/17 30 100 227/114 229/110 111 114 200   
   SEEN-BY: 229/206 300 317 400 426 428 470 550 616 664 700 230/0 266/512   
   SEEN-BY: 267/800 280/5003 282/1038 291/111 292/854 2226 8125 301/1   
   SEEN-BY: 310/31 320/219 322/757 335/364 341/66 342/200 396/45 410/9   
   SEEN-BY: 423/81 460/58 633/280 712/848 770/1 3 100 330 340 772/210   
   SEEN-BY: 772/220 230 5020/400 5058/104 5075/35   
   PATH: 770/3 1 218/840 221/6 1 292/854 229/426