4UXTDhskDWR4peJeKiMop3U3VFCc!QI49vwl3z4bIEXTp6jAX41TDXvHIkAuf40O   
   huq8YwajCuBLY2ISb2j3SNbth6eWrTjiNiyLKbeX!Cyo+tcvBIakf3SpvIEbcI5eVZ8QAhji3Jfnk   
   properly   
   From: "Steven Levine"    
      
   On Tue, 27 Dec 2011 15:04:58 UTC, "Eric Erickson"    
    wrote:   
      
   Hi,   
      
   > drives and keep on trucking. But alas that turns out not to be the case. When   
   > I put my hard drive into the new unit it boots XP just fine and all functions   
   > as expected. But when I attempt to boot the eCS V2.1 partition, it starts   
   > doing the JFS checks, make a loud clunk noise and then just shuts off.    
      
   I tend to agree with Andreas that you have a hardware issue.  Of    
   course shuts off is a pretty vague problem description, but so it    
   goes.   
      
   If it were me, I would start doing some unit testing to isolate what    
   is really failing. I would haul out dfsee and check that the drive is    
   readable and contains no bad sectors.   
      
   > The old unit is 2668-H2U and the new is 2687-D5U. The major difference is the   
   > new unit is a little faster processor. I'm still doing a deep dive on the   
   > specs to see what else could be different.    
      
   I doubt very much that your issue has anything to do with specs.   
      
   > Is this a potential APCI issue or possibly just something different?   
      
   I doubt ACPI has anything to do with it.  IIRC, the IBM supported APM    
   on the T43.  If so, it's probably a better choice than ACPI.   
      
   Steve   
      
   --    
   ---------------------------------------------------------------------   
   Steven Levine    
   eCS/Warp/DIY etc. www.scoug.com www.ecomstation.com   
   ---------------------------------------------------------------------   
      
   --- Internet Rex 2.31   
    * Origin: The gateway at Omicron Theta (1:261/20.999)