REPLY: 1:19/50.1 5fb3fe79   
   MSGID: 1:105/10.1 5fb45480   
   CHRS: UTF-8 2   
   TZUTC: -0800   
   Greetings Kevin!   
      
   Tuesday November 17 2020 10:44, you wrote to me about an urgent matter!:   
      
    KN> Hello Rick.   
      
    KN> 14 Nov 20 08:33, you wrote to all:   
      
    KN> I am using v1.60 and here is my entries into config.sys. I am not sure   
    KN> if 2k works the same or not, But this might get you headed in the   
    KN> right direction.   
      
    KN> REM SIO Setup   
    KN> DEVICE=c:\sio\sio.sys (COM1:115200,INTERNET:3F8,4,-)   
    KN> (COM2:115200,INTERNET:2F8,3,-) (COM3:115200,INTERNET:3E8,4,-)   
    KN> (COM4:115200,INTERNET:2E8,3,-)   
    KN> DEVICE=c:\sio\vsio.sys   
    KN> DEVICE=c:\sio\vx00.sys   
      
   Thankyou for that... I did try your config lines with vsio2k and crashed   
   system... So I installed 160 and it seems to boot fine and claims to be   
   running... when I run vmodem from a command prompt it loads and says that it   
   is fine.. So setting those com ports to "internet" is that the only variable?   
   Is there no where to mention telnet and perhaps a port? or does it just listen   
   for any traffic?  So far I can get it to react to an incoming telnet....   
      
   ANyhow thank you I am another step further I suppose...   
      
      
      
   ----   
   Regards,   
      
      
    Rick Smith (Nitro)   
      
   ... A job is nice, but it interferes with my BBSing...   
   --- GoldED+/LNX 1.1.5-b20180707   
    * Origin:  ----> Abacus Sysop Point --->>>>bbs.abon.us:2323  (1:105/10.1)   
   SEEN-BY: 1/123 18/200 90/1 105/10 11 81 82 120/340 123/131 226/30   
   SEEN-BY: 227/114 702 229/101 275 424 426 452 550 616 664 1016 240/5832   
   SEEN-BY: 249/206 317 400 292/854 317/3 322/757 342/200 633/280   
   PATH: 105/10 81 229/426