REPLY: 1:340/202 5fb00799   
   MSGID: 1:19/50.1 5fb3fe79   
   CHRS: IBMPC 2   
   TID: FastEcho 1.46.1 43230   
   Hello Rick.   
      
   14 Nov 20 08:33, you wrote to all:   
      
    RS> installed vsio2k and it appears to work.. vmodem starts and runs no   
    RS> errors... However for the life of me I cannot find documentation to   
    RS> have it listen for telnet ports.. Ive searched high and low, logged on   
      
   I am using v1.60 and here is my entries into config.sys. I am not sure if 2k   
   works the same or not, But this might get you headed in the right direction.   
      
   REM SIO Setup   
   DEVICE=c:\sio\sio.sys (COM1:115200,INTERNET:3F8,4,-)   
   (COM2:115200,INTERNET:2F8,3,-) (COM3:115200,INTERNET:3E8,4,-)   
   (COM4:115200,INTERNET:2E8,3,-)   
   DEVICE=c:\sio\vsio.sys   
   DEVICE=c:\sio\vx00.sys   
      
   The first DEVICE line is assigning the comports to use for telnet. I have 4 of   
   them setup. vsio and vx00 are DOS drivers I believe. s   
      
      
   Kevin   
      
   --- GoldED+/EMX 1.1.4.7   
    * Origin: Razor's Domain/2 BBS - bbs.razorsdomain.com:23230 (1:19/50.1)   
   SEEN-BY: 1/123 15/0 18/200 19/25 33 36 50 20/4609 90/1 105/81 106/201   
   SEEN-BY: 106/633 987 116/18 120/331 340 123/131 140 124/5014 5016   
   SEEN-BY: 130/803 153/7715 218/700 222/2 226/30 227/114 702 229/101   
   SEEN-BY: 229/275 424 426 452 550 616 664 1016 230/150 152 240/1120   
   SEEN-BY: 240/5832 249/206 317 400 250/1 261/38 100 1466 266/512 267/155   
   SEEN-BY: 275/100 282/1031 1056 291/100 111 292/854 317/3 320/119 219   
   SEEN-BY: 322/757 340/400 341/66 342/200 387/21 25 396/45 633/0 267   
   SEEN-BY: 633/280 281 384 410 412 640/1321 1384 712/620 848 770/1 801/161   
   SEEN-BY: 801/189 2320/105 3634/12 5020/1042   
   PATH: 19/50 396/45 261/38 712/848 633/280 229/426