From: tholen@antispam.ham   
      
   I'm trying to configure RSJ for use in a multi-burner environment.   
   Things were fine up until recently, when I replaced an old drive   
   with a Plextor 870A.  If I let LOCKCDR.FLT do its thing as in the   
   past, all the drives will be recognized by RSJ and converted into   
   drives that RSJ can use.  The problem is that the autodetect   
   function for the new Plextor drive sets it up for CUESHEET DAO mode,   
   which doesn't work right.  If I edit the cddrv.inf file and change   
   the DAO mode to RAW-3, then the Plextor drive works properly.   
   However, apparently I need to modify CONFIG.SYS to get LOCKCDR.FLT   
   to use the new entry in the cddrv.inf file.  My CONFIG.SYS entry is   
      
   BASEDEV=LOCKCDR.FLT -d -n -v -i:"PLEXTOR DVDR   PX-870A "   
      
   So now everything works on the Plextor, but the problem is that RSJ   
   doesn't recognize the other drives.  If I add additional lines to   
   CONFIG.SYS similar to the above but for each of the other drives,   
   then I see three sets of output during the boot process, with the   
   drives not listed in the -i section being ignored.   
      
   Anybody out there using RSJ with multiple drives, one of them being   
   manually configured with cddrv.inf?  If so, how are you doing it?   
      
      
   --- Internet Rex 2.31   
    * Origin: Aioe.org NNTP Server (1:261/20.999)