Firefox/4.0b8pre SeaMonkey/2.1b2pre   
   hCOKbTR`[8R\MTM^CT1A^BL@[N:`T\l73PAkJnBTh;MLnJdI7T2cX43^S?B   
   From: Lars Erdmann    
      
   > I think I've discovered why USBcfg hangs when Lars drivers are in use.   
   >   
   > The driver build level detection code in USBcfg is looking for a string   
   starting with a '@' followed by a '#' and ending with a '#' - ie @#IBM:10.162#   
   >   
   > Lars drivers id string starts with '@@' - ie @@#Lars Erdmann:10.163#   
   >   
   >   
   > So, USBcfg is probably "going around in circles" trying to find the   
   "standard" build level identifier string.   
   >   
   > Looks like I'll have to add this to the list of minor bits to do on the next   
   update of USBcfg - unless Lars reverts to the "standard" identifier string   
   with just the 1 '@'.   
   >   
   Hm. I cannot see this here. If I run bldlevel.exe it looks ok. It does not   
   show that extra '@'.   
   I also did not add an extra '@' to the buildlevel string. It's mere   
   coincidence.   
      
   Lars   
      
   --- Internet Rex 2.31   
    * Origin: Arcor (1:261/20.999)