Firefox/4.0b8pre SeaMonkey/2.1b2pre   
   jhgRXUnj7^79F7R^CT1A^BL@[^W7WllBZAEh]L9HWQOSdIFPMZ50XiK4P[R   
   From: Lars Erdmann    
      
   Hallo Dave,   
      
   why are you listing only one OHCI controller from the pci.exe output when in   
   fact you have 2 of them ?   
   I will have to look into the detection logic (obviously HCIMONIT is able to   
   detect them, I'll have   
   a look what it does differently from what the drivers do ...).   
   I assume you DO load OHCI drivers from config.sys ? In what order do you load   
   USBOHCD.SYS / USBEHCD.SYS ?   
   Can you revert the order and retry ?   
      
   Are you saying that on your system you have NO UHCI even though you have EHCI   
   ? In other words: EHCI "builds   
   on top of" OHCI and not on UHCI ?   
      
      
   Lars   
      
   Dave Yeo wrote:   
   > Lars Erdmann wrote:   
   >> I have updated the USB host controller drivers   
   >> USBUHCD.SYS,USBOHCD.SYS,USBEHCD.SYS.   
   >> I have now placed these on hobbes.   
   >> They will eventually make it into directory:   
   >> /pub/os2/system/drivers/misc   
   >>   
   >> Lars   
   >   
   > I was hoping these would help me but with both the stock and yours I get the   
   message that no OHCI drivers can be found on the PCI bus. The EHCI driver   
   causes a crash in the kernel when loading JFS. HCIMONIT does report 2 PCI USB   
   OHCI host   
   > controllers and one EHCI.   
   >   
   > Vendor 10DEh Nvidia Corp   
   > Device 0067h nForce2 OHCI USB Controller   
   > Command 0007h (I/O Access, Memory Access, BusMaster)   
   > Status 00B0h (Has Capabilities List, Supports 66MHz,   
   > Supports Back-To-Back Trans., Fast Timing)   
   > Revision A4h, Header Type 80h, Bus Latency Timer 00h   
   > Minimum Bus Grant 03h, Maximum Bus Latency 01h   
   > Self test 00h (Self test not supported)   
   > PCI Class Serial, type USB (OHCI)   
   > Subsystem ID 0C111043h Unknown   
   > Subsystem Vendor 1043h ASUSTeK Computer Inc   
   > Address 0 is a Memory Address (anywhere in 0-4GiB) : ED083000h   
   > System IRQ 5, INT# A   
   > New Capabilities List Present:   
   > Power Management Capability, Version 1.1   
   > Supports low power State D1   
   > Supports low power State D2   
   > Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold   
   > PME# signalling is currently disabled   
   > Current Power State : D0 (Device operational, no power saving)   
   >   
   > Vendor 10DEh Nvidia Corp   
   > Device 0068h nForce2 EHCI USB 2.0 Controller   
   > Command 0006h (Memory Access, BusMaster)   
   > Status 00B0h (Has Capabilities List, Supports 66MHz,   
   > Supports Back-To-Back Trans., Fast Timing)   
   > Revision A4h, Header Type 80h, Bus Latency Timer 00h   
   > Minimum Bus Grant 03h, Maximum Bus Latency 01h   
   > Self test 00h (Self test not supported)   
   > PCI Class Serial, type USB 2.0 (EHCI)   
   > Subsystem ID 0C111043h Unknown   
   > Subsystem Vendor 1043h ASUSTeK Computer Inc   
   > Address 0 is a Memory Address (anywhere in 0-4GiB) : ED082000h   
   > System IRQ 11, INT# C   
   > New Capabilities List Present:   
   > USB 2.0 EHCI Debug Port Capability   
   > Power Management Capability, Version 1.1   
   > Supports low power State D1   
   > Supports low power State D2   
   > Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold   
   > PME# signalling is currently disabled   
   > Current Power State : D0 (Device operational, no power saving)   
   >   
   > etc   
   > Dave   
   >   
      
      
   --- Internet Rex 2.31   
    * Origin: Arcor (1:261/20.999)