From: piesse    
      
   Alex Taylor wrote:   
   >    
   > Try the slimmed-down PPD file I sent you first.  If you still get this   
   > trap, we can proceed to the next step to try and analyze it.  (See    
   > below.)   
      
   Partial success: the file imports fine, and lucide doesn't crash any    
   more when trying to print through the printer.   
   However, it doesn't print yet.   
   There are two strange things:   
   1)The "Job properties" in the printer driver tab doesn't open up.   
   2)The printer selection menu of the os/2 applications never shows the    
   the "pscript.HP laserjet 2055" that I have selected and shows in the    
   printer driver tab, but any driver that had been associate with the    
   printer previously. So, if I change the driver to ibmnull and then back    
   to the new driver, the new driver will be shown in the printer driver    
   tab of the printer, but the application will still use ibmnull.   
      
   >    
   > OR, you can just take James's suggestion and use the existing OS/2   
   > 2300PS driver.   
      
   >    
   > BTW, you shouldn't need to use CUPS in either case.  According to the   
   > printer specs, it's a native PostScript printer, so you can just use   
   > the OS/2 PSCRIPT driver (once you get the PPD imported; or even not, if   
   > you use the 2300 driver as above).   
      
   ok, I will go that way (I already have an object for the same printer    
   configured via LPRPORT). I only though that cups was going to become the    
   standard print system in eCS, and tried to experiment with it.   
      
      
   Thanks again   
      
   piesse   
      
      
   --- Internet Rex 2.31   
    * Origin: The gateway at Omicron Theta (1:261/20.999)