home bbs files messages ]

Just a sample of the Echomail archive

Cooperative anarchy at its finest, still active today. Darkrealms is the Zone 1 Hub.

   MBSE      The Linux/FreeBSD MBSE BBS Support Echo      2,445 messages   

[   << oldest   |   < older   |   list   |   newer >   |   newest >>   ]

   Message 793 of 2,445   
   Gert Andersen to Vince Coen   
   Roll call results   
   11 Aug 13 10:01:04   
   
    * Reply to message originally in area CarbonArea   
      
   Hello Vince!   
      
   Sat Aug 10 2013, Vince Coen wrote to Gert Andersen:   
      
    >> Here PATH for mbse is:   
      
    >> PATH=/opt/mbse/bin:/usr/lib64/icecc/bin:/usr/local/bin:/usr/bin:/usr/g   
    >> ames:/usr /   
      
    >> It is the first item in the line and this is set up using the SETUP.sh   
    >> script in mbsebbs/scripts in line 328 see {   
      
    >> export PATH=\$HOME/bin:\$PATH   
    >> export MBSE_ROOT=\$HOME   
    >> }   
      
    >> The gentoo script seems to have errors in that regard BUT I do not run   
    >> gentoo so cannot confirm it. Also I could be talking a lot of twadle !   
      
      
    VC>Now had a closer look at that script and the above statement is total    
    VC>rubbish   
    VC>as it is used to run mbse not set it up. SETUP.sh is still used so the    
    VC>path   
    VC>should have been created corrrectly unless you did not run it.   
      
      
   AS I have used MBSEBBS from version 0.0.92 and upgraded it up to 0.95.15 -->   
   1.0.0 with only upgraded way for it and SETUP.sh only been used once for   
   version 0.0.92 and the other other versions used old setup there was done.   
   So I used the working setting and I just unpack from /opt/mbse as tar xfvj   
   /opt/mbsebbs-1.0.0.tar.bz2   
   ./configure   
   make   
   su -> root pwd   
   make install   
      
   the used init.gentoo script to be :   
   PATH=${PATH}:${MBSE_ROOT}/bin   
   and the setting in init.gentoo have default as   
   PATH=/sbin:/bin:/usr/sbin:/usr/bin:${MBSE_ROOT}/bin   
      
   For last mbse 2 install on my sysop point 1 mbse install have I just tried   
   something new with in init.gentoo script for version 1.0.01 to do this.   
   PATH=${PATH}:/sbin:/bin:/usr/sbin:/usr/bin:${MBSE_ROOT}/bin   
   and it is working fine.   
      
      
     Take care,   
               Gert   
      
         - Get the best with linux -    
      
   --- Msged/LNX 6.2.0 (Linux/2.6.39-gentoo-r1 (x86_64))   
    * Origin: * The KofoBBS at http://www.kofobbs.dk * (2:230/150)   

[   << oldest   |   < older   |   list   |   newer >   |   newest >>   ]


(c) 1994,  bbs@darkrealms.ca