Gert Andersen wrote to All:   
   GA> Hello All!   
   GA>    
   GA> I have reinstall a new system on my fido2 pc with Gentoo and this is now    
   GA> changed from using eth0 to enp2s0 in interface card and after installing    
   GA> xinetd is xinetd not start in reason of it like to use the old eth0 so my    
   GA> mbse it not right working self if it polls out but not running right as it    
   GA> should for the telnet connection to get the sysop as first user for    
   GA> mbsebbs and linux user.   
   GA> I have tried to find out where I in linux config files shall change eth0    
   GA> to be enp2s0.   
   GA> There is then 2 choise there is either.   
   GA> 1. make linux use the old eth0   
   GA> 2. get changed xinetd to use enp2s0 instead of eth0.   
   GA>    
   GA> It is just the newuse of interface keep going changed eth0 to enp2s0 and    
   GA> change it again to eth0, self if I try to make linux to keep it to be    
   GA> eth0.   
   GA>    
      
   ArchLinux does the same thing.  In their network setup docs   
   (https://wiki.archlinux.org/index.php/Network_configuration) it shows how to   
   change the device name using the udev rules.  You could probably doe the same   
   sort of thing with Gentoo.   
      
   I have not tried this so your mileage may vary.   
      
   Stephen   
         
      
   ---   
   The Bit Bucket BBS - telnet://bbs.thebitbucket.ca   
      
   --- MBSE BBS v1.0.6 (GNU/Linux-x86_64)   
    * Origin: The Bit Bucket BBS (1:342/13)