Bill McGarrity wrote to All:   
      
    BM> Hiya....   
      
    BM> Quick question. I'm trying to input a session level password in the   
    BM> Node Mgr and the area is not accessable for me to change it.  I'm   
    BM> using FD 2.25+ as the mailer type and using Synchronet mail tosser.   
    BM> The sbbs echocfg will allow me to put in a pkt password but I really   
    BM> don't care about that.   
      
   Dunno about FD 2.25 as I've never used it, but I use FD (Up to 2.20). I   
   also have 'type of .msgs' set to Opus 1.02. Dunno if that's part of the   
   problem or not. I also have TransX Mode set to compatable.   
      
    BM> BTW, the TransX field is set to compatable although I have it toggled   
    BM> off.   
      
    BM> One other thing.... I have an updated and compiled FD nodelist in the   
    BM> path that IRex asks for and when I toggle "Send to Unlisted Nodes" to   
    BM> Yes, it never stays and goes back to No.  Right now I am using   
    BM> route.rex but I'd rather not have to route netmail through my uplink.   
      
   This is one of the quirks of IREX...you can set 'send to unknown nodes' to   
   yes and exit the rexcfg and then return to it and that setting will always   
   be set to No...dunno why. BTW, I use a GoldEd compiled nodelist rather   
   than the FD compile.   
      
   The route.rex file can be edited to send mail directly to any node listed   
   in the node manager, but not a node Rex can only find in the nodelist.   
   Sometimes rex will read the nodelist, other times it won't.   
      
    BM> My copy of Irex is registered... 50 nodes and server functions to 2   
    BM> users. Will I need a different key and string to activate those   
    BM> functions?   
      
   Nope. You have the same setup that I have and it works as advertised, but   
   has a few hangups that can no longer be addressed by the author because   
   he's abandoned the package.   
      
    BM> Any ideas?   
      
   I've run into the session password thing before, but I don't recall what   
   it was that finally allowed that field to be used. It has something to do   
   with the way you've configured the node, but I don't recall the switch   
   that turns that session field on/off. It might do some good to delete that   
   node's config, exit rexcfg and start over...sometimes rex doesn't write   
   the cfg files correctly.   
      
      
            R\%/itt   
      
      
   --- GoldED+/W32 1.1.5-31012   
   --- D'Bridge 3.92   
    * Origin: Lone-Star BBS - San Antonio, Texas - USA (1:387/22)