02 Oct 12 15:28, Anthony Rico wrote to Roy Witt:   
      
      
    RW>> The tracert showed a few timed out delays, so I'd advise that you   
    RW>> config REX with a little more time to resolve the route before it   
    RW>> gets to d1st.org (50.142.74.88)...   
    RW>>   
    RW>> Also, make sure that you have the right port open in any router you   
    RW>> may be   
      
    AR> I was looking for this configuration option but couldn't find it   
    AR> related to dns. where can I find this setting so I can change it.   
      
   In your node manager setup area you'll find an option to send to a FTP   
   site. Click on Outbound messages until you see 'toss to an FTP site' come   
   up, then drop down to Configure and enter the particulars of the node   
   you're configuring. When all else fails, there is a IREX info document   
   available using the F1 key. Don't forget to select Node active and answer   
   YES to it and Crash Mail if you wish mail to go out right away. Also make   
   sure that Inbound messages is configed the way you want that to work.   
      
   Upon exit back to Node manager, you should see the node address, three   
   letter characters and the sysops name, all on one line. The three letters   
   indicate what that node's config is. B means BinkD, F means FTP and Y or N   
   means the node is either active, or not, as in FFY or FFN for an FTP   
   node...   
      
                   R\%/itt   
      
      
   ... Mark Owen: "Hey, did you ever hear anything about that beer?   
   ... Fellow SEAL: "You believed that s**t, I bet you voted for change too,   
   ... SUCKER."   
      
      
   --- GoldED+/W32 with D'Bridge 3.82   
    * Origin: Texas Lone-Star - Texan, American, USAian  (1:387/22)