Brer Benny Pedersen wrote to Brer Roy Witt about HotdogED Device   
   Compatibility List #7:   
      
    RW>> point, but I didn't like that idea as there are no points in Z1   
    RW>> anymore, unless one is using a remote system of their own. So, I   
    RW>> re-configed it to be a node, but your software says it must be 4D,   
    RW>> so it is now configed as 1:387/23.0 ... Why does this thing have to   
    RW>> be 4D?   
      
    BP> Janis gives point addresses in z1 if she is the only one, ask nicely   
    BP> for one might work, even if it did not i still dont understand why   
    BP> not let it run as a point ?   
      
   I don't need to ask her for a point, as NC I can do that. But I wasn't   
   aware that she issued any points, but rather, she has listed a few nodes   
   as ZINs. I was once a ZIN, 1:1/22   
      
    BP> if node version of hotdoged comes it would still be nice, but its low   
    BP> powered node then that still not handle tic files, well it still in   
    BP> progress, but i think point needs is smaller then node needs   
      
   I think points are exclusive to Z2 because the still high POTS calling   
   rates.   
      
      
      
            R\%/itt   
      
      
      
   --- GoldED+/W32 1.1.5-31012   
   --- D'Bridge 3.92   
    * Origin: South Texas Hub - Gulf Coast Distribution (1:387/22)