Hello Wilfred,   
      
   > about: "Re: Golded+ on 64b Linux":   
      
   >>> Change this to:   
   >>> if [ -n "$SCREEN" -a -s "$SCREENRC_GOLDED" ]; then   
   >>> And try again...   
      
   >> When I run the golded script with the quotes placed as indicated I don't   
   >> get the "unexpected operator" response. But... gedlnx doesn't load either.   
   >> I am immediately returned to the terminal prompt.   
      
   >I had a closer look at the script. And it's strange you even get that far into   
   > the script. When you don't have a Russion locale installed you shouldn't get   
   > past line 15 of the script. And that just executes the gedlnx...   
      
   The implied suggestion from the Golded scripts was to use the golded script to   
   launch Golded. But upon examining the script file it became evident that it   
   dealt with ".ru" Russian locales. Hence my decision to try to launch Golded   
   manually. After first downloading the Golded+ source I had setup a basic   
   golded.cfg file to use in running Golded. At first using the source obtained   
   from the gpsrc-115-20161221.tgz. Running ./gedlnx (With golded.cfg in the same   
   directory as gedlnx) left me right back at the command prompt.    
      
   After obtaining the golded+ source from the gpl115-20161221.zip which was   
   created from running the dist-gpl.sh script and compiling Golded+. Loading   
   gedlnx (Again with golded.cfg in the same directory as gedlnx caused Golded+   
   to load ok. This is without specifying a golded config file on the commandline.   
      
   I will write a small bash file to load Golded in the future and also   
   complicate the config file more to meet my particular needs.    
      
      
   Jeff   
      
      
   --- BBBS/Li6 v4.10 Toy-3   
    * Origin: The OuijaBoard - Anoka, MN  (1:282/1031)