Hello andrew,   
      
   On 07 Jun 15 03:33, andrew clarke wrote to Michiel van der Vlist:   
      
    MV>> No, to write a message in UTF-8, you do not need to use an   
    MV>> external editor. What you need is the proper translation table   
    MV>> from your local set to UTF-8.   
      
    ac> But my local set is UTF-8.   
      
   I had the same issue, and as I told Mark, I just basically created a table    
   named utf8_utf8.chs and specified the ID, version, level parameter, then UTF-8    
   for the in and out fields and that was it. Obviously it doesn't need any    
   translation if you are already using UTF-8 as your local set.   
      
   That seemed to fix my issue with the level parameter being 2 instead of 4, at    
   least.   
      
   Regards,   
   Nick   
      
   --- GoldED+/LNX 1.1.5-b20130910   
    * Origin: thePharcyde_ telnet://bbs.pharcyde.org (Wisconsin) (1:154/701)