MSGID: 2:221/1.59 1a0e2713   
   REPLY: 1:229/426 E3FAA54E   
   TZUTC: -0500   
   TID: AA 61.6   
   Hi Nick,   
       
   I've been experimenting with D'Bridge for a little while now, and have run   
   into a few issues with it.  ;)   
       
   [1] When constructing a netmail message, it finds the relevant name with the   
   handy integration of the nodelist, but it changes the zone number to 1 if the   
   original address was written for a zone 2 or 3 destination.  Then, when the   
   program is queued/polling mode, it reports "no such address" for those   
   messages and sits on a Hold.   
       
   [2] What is the proper way to integrate the Z2PNT nodelist? I've tried just   
   adding it in the same section where the regular full NODELIST is recorded, but   
   the address lookups would then fail. As a consequence, a message to another   
   point address does not seem to be possible.   
       
   [3] I've adjusted the display size to about 40 lines, but when reading a   
   message that exceeds 40 lines, and scrolling down, the message content   
   "duplicates" for about 10 lines before the rest of the actual message shows   
   up.    
       
   I have a few more questions, but those are the main ones.   
      
   --- D'Bridge 4   
    * Origin: Mans Mazais Eiropas D'Bridge Punkts (2:221/1.59)   
   SEEN-BY: 1/123 90/1 103/705 154/10 203/0 221/1 6 360 227/114 229/426   
   SEEN-BY: 229/1014 230/0 240/5832 249/1 206 317 400 280/464 5003 292/854   
   SEEN-BY: 317/3 322/757 342/200 396/45 423/81 120 633/280 2452/250   
   PATH: 221/1 280/464 229/426