TID: FMail-lnx64 2.2.1.0   
   RFC-X-No-Archive: Yes   
   TZUTC: 0100   
   CHRS: UTF-8 2   
   PID: GED+LNX 1.1.5-b20161221   
   MSGID: 2:280/464 659fab19   
   REPLY: 2:250/8 659ee32b   
   Hi Louis,   
      
   On 2024-01-10 18:28:32, you wrote to All:   
      
    LN> What's the correct way to configure a link without a pkt password?   
    LN> Currently I have the following setup but doesn't let them connect:   
      
    LN> node 2:1/1@network address:24554 password,,password i   
      
   You don't need to configure a pkt-password in your binkd config unless you are   
   also using the 'share' option in your binkd.conf. And I very much doubt you   
   are. The pkt-password in normally set (or not if not specified) by your tosser.   
      
   And don't specify the default port.   
      
   And you also don't need to specify the 'flavour' ("i"), unless you are using a   
   filebox outbound directory for this node, which you haven't configured in this   
   line, so leave it out.   
      
   So the 'node' line would become:   
      
     node 2:1/1@network host_address password   
      
      
      
   Bye, Wilfred.   
      
   --- FMail-lnx64 2.2.1.0   
    * Origin: FMail development HQ (2:280/464)   
   SEEN-BY: 10/0 1 15/0 90/1 102/401 103/1 705 105/81 106/201 124/5016   
   SEEN-BY: 128/260 129/305 135/225 153/757 7715 154/10 30 203/0 214/22   
   SEEN-BY: 218/0 1 215 601 700 720 820 840 860 870 880 930 221/0 226/30   
   SEEN-BY: 227/114 229/110 112 113 200 206 275 307 317 426 428 470 550   
   SEEN-BY: 229/664 700 240/1120 5832 266/512 280/464 5003 5555 282/1038   
   SEEN-BY: 291/111 292/854 8125 301/1 310/31 320/219 322/757 341/66   
   SEEN-BY: 341/234 342/200 396/45 423/120 460/58 467/888 633/280 712/848   
   SEEN-BY: 770/1 5020/400   
   PATH: 280/464 103/705 218/700 229/426