Hello There,   
      
      
   I have been having a popping loop issue between BBBS and Mystic. I have both   
   BBBS and Mystic setup on separate machines here. I did a test with BBBS and   
   Mystic here. As a base I made sure that there was no mail/files waiting in   
   BBBS's outbound to go out to Mystic (1:282/1032). I did a queue check   
   and I got:   
      
   Nodenumber  Age Flags  Bad Busy Msgs  ArcMail  Files   
   ----------  --- ------ --- ---- ----  -------  -------   
      
   I did a manual poll in BBBS to poll 1:282/1032. The poll showed up in the   
   queue as it should:   
      
   Nodenumber    Age Flags     Bad Busy Msgs  ArcMail    Files   
   ----------    --- --------- --- ---- ----  -------   -------   
   1:282/1032.0   0   IC   D    0   0    1      0kB       0kB   
      
   BBBS polled Mystic (1:282/1032) as it should of. Once the poll was completed   
   BBBS polled Mystic again repeatedly. Until I deleted the poll from the queue.   
   At which time BBBS immediately stopped polling. It seems that either BBBS   
   doesn't see the poll as having been completed and then deleting the poll from   
   the queue. Or Mystic isn't terminating the connection in a manner that BBBS is   
   properly recognizing. I include Mystic primarily because this polling loop   
   behavior only seems to happen when BBBS connects to Mystic systems. I have   
   polled a variety of other non Mystic systems and have never seen this behavior.   
       
   I had resisted posting on the matter in the Mystic or BBBS echos as I didn't   
   want it to seem like I was bashing either piece of software. But... Maybe if I   
   do, it might draw more attention to the matter from others. I feel it is   
   important   
   to note that I am also in discussion with Kim on the matter.   
      
      
   Jeff   
      
   --- BBBS/Li6 v4.10 Toy-3   
    * Origin: The OuijaBoard - Anoka, MN  (1:282/1031)