Re: Dial-Up Modem (Fastest supported on FiOS Gigabit)?   
     By: Henri Derksen to Ozz Nixon on Fri Oct 27 2017 01:50 pm   
      
   Well, I finally received the new USRobotic USB 56k V.92 modem. I called Janis'   
   BBS (Zone 1)... and it worked.   
      
   Now, anyone in this echo a Modem/Direct/UART Guru?   
      
   What state do I need to put the modem in, to chain from mailer to BBS, or BBS   
   to a DOOR? I found one page on the net, but it says to put your modem in AT&D0   
   state. Then I can drop DTR, terminal host, run next App. As soon as I lower DTR   
   - NO CARRIER on ther terminal.   
      
   * Yeah, there are hundreds of dead BBSes I could dig through there code - but,   
   I like to talk to people who do it now, not old kludges. * I ahve built my   
   communications library from scratch, 99% 16bit assembly with built in 4kb   
   buffers to make migrating my old socket code over to dial-up easier. I tested   
   on direct wire at 115200 nand it works, all the way down to 300bps. But, I   
   digress... I have tried different strategies to go from program to program...   
   without success.   
      
   Ozz   
   --- SBBSecho 2.12-Win32   
    * Origin: SHENK'S EXPRESS, shenks.synchro.net (1:275/100)