On Sun, 30 Nov 2014, Ian Segers wrote to Bj”rn Felten:   
      
    BF> how do you put it in the proper "OUT" directory?   
      
    IS> When I process this message via sbbsecho.exe, it goes to the taurus   
    IS> outbound but as 1:340/400@outbound I have to manual change it to   
    IS> 1:340/400@fidonet then works   
      
   this seems to indicate that you are trying to operate your mailer in 5D format   
   when your tosser (sbbsecho) is only 4D... you must operate your mailer in 4D   
   also... that means that you'll have only one outbound directory defined and   
   others will be derived from it... all domains will appear the same... it is   
   the zone addresses that will make the difference...   
      
   what is your outbound directory definition in sbbsecho.cfg?   
   what is your outbound direcrory definition in argus/radius/taurus?   
      
    IS> netmail in taurus outbound  via *.msg the *.msg there but @   
    IS> 3:770/330@fidonet which is my address   
    IS> if the netmail is in pkt form in dir of out in taurus outboound its   
    IS> @ 3:770/330@fidonet with no pkt attached   
      
   this is hard to understand... PKT names are 8.3 format... are you trying to   
   use taurus' dynamic netmail packing capability? taurus and sbbsecho should not   
   know of the other's MSG directory... sbbsecho handles its MSG directory all on   
   its own and in its own special way... it is much different than what other   
   mailers would expect...   
      
   )\/(ark   
      
    * Origin:  (1:3634/12)