Hello Patrik!   
      
   15 Aug 17 13:31, you wrote to me:   
      
    PA> Strange that it does not boot from the internal scsi with the   
    PA> warpengine connected. Does the drives connected to the internal scsi   
    PA> show in early startup or show any other indication of working when the   
    PA> warpengine is connected?   
      
   No, they don't show up in Boot Menu.   
      
    PA> The warpengine scsi is much faster nevertheless, but I understand that   
    PA> it is annoying.   
      
   Sure, but the NSD docs don't list warpdrive.device as supported device nor   
   found I an evidence that it is supporting large disks in general.   
      
   However, it seems as if I don't need just pfs-aoi, but also some other parts   
   of pfs. Hints are welcome! ;-)   
      
    PA> I am using an AEC-7722 bridge, which is actually a wide scsi bridge   
    PA> for ATAPI devices like CD-ROMs etc, but I have changed the firmware to   
    PA> that from the ATA equivalent AEC-7726Q. This bridge is about as large   
    PA> as the back och a 5.25" CD (where it was intended to be mounted), so   
    PA> it is quite bulky, but together with the IDE->SATA adapter, the   
    PA> SATA->mSATA adapter the overall package is about half a CD-ROM. The   
    PA> only reason for using the 7722 was that they used to be sold for under   
    PA> 30USD on aliexpress a few yeats ago.   
      
   Well, I got my 7720U for a good price as well, otherwise I would have opted   
   for the ARS2000SUP, because of the SATA interface. Alas, I would have had the   
   same issues with WarpEngine and PFS then, I think... ;)   
      
   Ingo   
      
      
   --- GoldED+/LNX 1.1.5--b20170303   
    * Origin: AmigaXess - back in FidoNet after 17 years  (2:2452/413)