11-29-18 11:07 Holger Granholm wrote to Charles Stephenson about Re: BBS'ing   
   and HAM Radio   
   Howdy! Holger,   
      
    HG> @MSGID: <5C01187B.1964.amtradio@capitolcityonline.net>   
    HG> In a message on 11-28-18 Charles Stephenson said to All:   
   ---Snip---   
      
    HG> Locally we did also have a packet radio BBS operating at 1200 bps on 2m   
    HG> but because I found it too slow I made a 70cm (432 MHz) transceiver for   
    HG> 9600 bps packet radio.   
      
    HG> When I had it going the local club decided to close down the packet   
    HG> radio system. Consequently I added a microphone and speaker amplifiers   
    HG> and had a 70cm transceiver.   
      
    HG> Transceiver is a combined transmitter/receiver in one unit.   
      
    HG> So much this time. Any further questions will be replied to another   
    HG> time   
      
   I've been thinking over and over about asking about the packet radio XCVR   
   that You built.   
      
   I was wondering if the circuit used IC's or XSISTORS only or did it have   
   Vacuum Tubes in it?   
      
   Is the Schematic for it on some Web Site?   
      
   I ain't built any circuits for ages but I would like to see the Schematic   
   for the Rig You built for packet radio, and later added Audio to it   
   (for A.M. I suppose?).   
      
   Thanks es 73 de Ed W9ODR   .          .   
      
      
   ... 8000 bolts to make a car; only 1 nut to scatter them.   
   --- MultiMail/MS-DOS v0.49   
    * Origin: capitolcityonline.net * Telnet/SSH:2022/HTTP (1:2320/105)