ts790

                  CROSS BAND REPEATER MOD
  To operate the TS790A in the repeater cross band mode,diode D32 on the
  control board must be opened.In addition,two resistors must be soldered
  to a 13 pin din plug which will be connected to the ACC. 2 jack on the
  back panel of the transceiver.

                  TO LOCATE AND OPEN D32
  1   Disconnect the power supply and antenna from the radio.
  2   Remove the 14 screws that secure the top and bottom covers.
  3   Carefully remove the top and bottom covers.
  4   Locate the control board. this is a vertically mounehind the front panel.
  5   Locate diode d32 towards the top right side of the board.
  6   Using a small pair of wire cutters,cut the lead of the diode. do not
      pull on the lead or the diode as this may tear the foil on the other
      side of the board.
  7   assemble the radio by reversing steps 1-3.

continued in ts790.1