Ref: 99980165
Title: LinkPlus Optimizer Release Notes Part No. 5630-00
Date: 06-28-88

Copyright 3Com Corporation, 1991.  All rights reserved.

LinkPlus Optimizer Release Notes
Part No. 5630-00
Publish Date 6/28/88

This document provides information related to the installation and
configuration of the LinkPlus Optimizer software.  Read this
information carefully (particularly if you have a
TokenLink Plus adapter) before installing or using your LinkPlus
software.

LinkPlus Optimizer supports 3+Menus, Version 1.2 or greater.

If you are using the TokenLink Plus adapter with 3+ verson 1.0 or 1.1,
use the following procedure after installation:


1. Copy the TOK605A.SYS driver file from the LinkPlus Optimizer
software diskette to the diskette created during the installation, or
the hard disk if you installed the software on a hard disk.

2. Replace the following line in the LDR.CFG file:

   device=tok605e.sys ...

   with

   device=tok605a.sys

To run the IBM 3270 NetBIOS application on a LinkPlus Optimizer
netstation, the adapter card must be set to interrupt IRQ2.  The /h
parameter within the NBA.EXE command line in the LDR.CFG file is not
supported and, therefore, should not be included.


NOTE:  The 3C program is not supported by this release of LinkPlus
Optimizer; however, the 3Console program is supported.  The 3+3270 and
3+EtherTerm are not supported by this release of LinkPlus Optimizer.
