Ref: 19880001
Title: MultiConnect Power Supply Requires Switch-Off After Interruption
Date: 2/27/90

Copyright 3Com Corporation, 1991.  All rights reserved.

Note:  The following description applies only to MultiConnect units with
power supplies marked "Manufactured by Valor - Assembled in Mexico" or
"Rev D."

After a line voltage interruption, the MultiConnect power switch must
be turned off for at least 15 seconds, then back on, before it will
power up properly.  This feature was built into the power supplies to force
the network administrator to investigate the source of the power fault.

If you do not desire this feature, you can obtain a new power supply,
marked "3Com 3823-02 Rev E."  Call an Authorized Service Center, a Complete
Network Center, or 3Com's RMA department for replacement options.

