Ref: 19780003
Title: Using QINSTALL Properly on a 3S/401
Date:  7/2/90

Copyright 3Com Corporation, 1991.  All rights reserved.

To properly use the QINSTALL program on a 3S/401 server, follow these
steps:

1.  Run the TAPEINS tape installation procedure.

2.  Reboot the server; it will display the messages "Address: xxxxxx" and
"Do Quick Install" on the LCD.

At this point, the workstation that had a 3C console connection will time
out and display the error

***Share server not responding***

then an A> prompt.

3.  Reboot the workstation with the Quick Install Workstation diskette #1.
Make sure that the correct adapter and settings have been selected for the
CONFIG.SYS file.

4.  Run QINSTALL at the A> prompt.

If you do not reboot the workstation (step 3), it will display this
message:

Searching for a new server...
New server found at address 020608cxxxxxx
Do you want to initilize this server? [Y|N]
Looking for Start server...
Looking for Name...
Looking for Locator...
***  Error: xerr = 54, xproc = 32***

*** Qlink to 3PLUS directory failed(54) ***

