Ref: 13680016
Title: Quick Setup Procedures for Local NB Brouters and Bridges
Date: 09/28/90

Copyright 3Com Corporation, 1991.  All rights reserved.

This procedure will help you to set up local NetBuilder Brouters
and Bridges quickly.  Read the Brouter Commands and Parameters Guide and
Brouter Operation Guide for detailed descriptions of the Brouter.  Read the
Internetwork Bridge Operation Guide for detailed descriptions of the Bridge.

1.  Connect a terminal to the console port of the NetBuilder system.

2.  Power on the terminal and NetBuilder, and wait for the self-test.

If NetBuilder passes self-test and "System Initialized and Running" appears
on the screen, then press Return to get the "NetLogin:" prompt.

3.  Log in as "root" (use lowercase letters), and press Return for the
password.  (There is no password until you assign one.)

4.  When you get a prompt, type "menu" and press Return.  The Main Menu
varies depending on the Brouter and Bridge software.  Set the configuration
parameters as shown below.

Note:  The Bridge software has no routing capabilities, so skip the IP and
XNS routing parameters when configuring a Bridge.

5.  Reboot the system after configuring the parameters.


SYS SERVICE MENU
   Set DATE = yy/mm/dd hh:mm
   SetD DaylightSavingTime = 0 or 60
   SetD NetMapTime = 60
   SetD TimeZone = 300 (Eastern) or 360 (Central) or 420 (Mountain)
                   or 480 (Pacific) and so on....

BRIDGE SERVICE MENU
   SetD CONTrol = Bridge (Bridging and Routing) or
                  NoBridge (only routing)

PORT SERVICE MENU
      No modification needed

PATH SERVICE MENU
      No modification needed

[[ IP ROUTING ]]
IP SERVICE MENU
   SetD CONTrol = ROute
   SetD !1 NETaddr = <IP address> [<subnet mask>]
   SetD !2 NETaddr = <IP address> [<subnet mask>]

ARP SERVICE MENU
   SetD !1 CONTrol = Proxy
   SetD !2 CONTrol = Proxy

RIPIP SERVICE MENU
   SetD !1 CONTrol = (TAlk, Listen)
   SetD !2 CONTrol = (TAlk, Listen)

[[ XNS ROUTING ]]
IDP SERVICE MENU
   SetD CONTrol = Route
   Add !1 NETnumber <XNS NETnumber>
   Add !2 NETnumber <XNS NETnumber>

RIPXNS SERVICE MENU
   SetD CONTrol = (Enable, Trigger)

