Ref: 10820001
Title: Making a Copy on a NetBuilder Already Running
Date: 11/07/89

Copyright 3Com Corporation, 1991.  All rights reserved.

On page 3 of the NetBuilder Release Memo for SW/NB-IB-2.0 (86-0205-00,
Revision 00), under "Making a Copy on a Unit that is Already Running,"
the procedure is inaccurate and possibly misleading.  Following are hints to
make it clearer.

Remember that when monitor mode is entered, the operating software is halted
and all traffic ceases to be passed.

On a system which has been freshly booted, a carriage return is required
to get to the prompt:

    Welcome to your Internetwork Bridge
    IB>

At this point, the user must change privilege to 'lnm' or 'gnm'.  Then
follow the procedure as printed until step 3.

Before performing step 3 (the "co x" command), enter "k" and press [Return]
to do a soft reset.  Failure to do this may result in a confused processor, a
possibly corrupted copy, or the unit resetting during the copy process.

Continue the procedure.  At step 10 the memo states that, if a "bt" is
entered, this may result in corruption of the operating system.  Substitute an
"rs" command.  This will reset the system and reboot, provided the correct
software is installed in the drive.

