Ref: 02880074
Title: TokenLink Plus Installation Guide Documentation Corrections
Date:  08/08/88

Copyright 3Com Corporation, 1991.  All rights reserved.

The Tokenlink Plus Installation Guide has a published error
located in, Testing the TokenLink Plus Board 3, sec. 3-7. The
page is titled Table   3-1. Diagnostic Tests (continued).


.br;TOKENLINK PLUS INSTALLATION GUIDE PART# 2119-00
.br;===============================================
.br;THIS GUIDE IS FEATURED IN 3C2506 PRODUCT  (POSSIBLY 3C604S PRODUCT)

The LAST paragraph in table 3, section 3-7, Table 3-1 Diagnostics Tests
(continued), should read as follows:

Press the cursor-up or cursor-down arrow keys to move line by line on
the menu; press the PgUp or PgDn key to move group by group. When the
cursor bar is on an item that you want to select, press the + key;
notice that the selected item appears as blinking text. The blinking
turns off when the item is deselected. To deselect an item, press the -
Key.

.br;TOKENLINK PLUS INSTALLATION GUIDE PART# 3635-01
.br;===============================================
.br;THIS MANUAL IS FEATURED WITH THE ADAPTER 3C605

The LAST paragraph in table 2, section 2-7, Table 2-1 Diagnostics Tests
should read as follows:

The Diagnostic Tests menu is initially set to run the Group1 test. The
test is high lighted on the screen to indicate it has been selected.
You can select a different set of tests by pressing UP ARROW or DOWN
ARROW, to move by lines through the menu, or PG UP or PG DN to move by
groups. When the cursor bar is over a test that you want to select,
press the + key, the text blinks while the cursor bar is over it, and
appears highlighted after the cursor has moved. To deselect a test,
press the - key.


This diagnostic is run in two separate Groups (1 or 2). If the
diagnostic is not RESET between groups (highlighting both groups
of tests) the board will pass all tests, hang up for a few
moments and then come back with an error message that reads:

.br;PACKET TRANSMISSION ERROR
.br;PACKETS XMIT: 1024
.br;PACKETS RCV: 1024
.br;ERROR SENDING PACKET
.br;SYSTEM STATUS BLOCK: 00 01 00 40 FF FE
.br;ADAPTER ERROR LOG: 00---------------00

.br;To select an item hit + key.
.br;to deselect an item hit - key.  (10/87)
