Ref: 02170007
Title: Jumper Settings for 2MB NETBuilder Drive
Date: 3/29/91

Copyright 3Com Corporation, 1991.  All rights reserved.

Before installing a disk drive during a NETBuilder upgrade, put the
jumpers in correct position on the disk drive by following these steps:

1.  Position the drive diskette slot away from you.

2.  Remove the jumper from FG and place it on the vertical pins that are
third from the left (column 2), position B C.  (See diagram.)

3.  On the vertical pin that is fourth from the left (column 1),
position A B, move the jumper from the up position to the down position.
(See diagram.)

The drive is now ready to install.

                       ____
               o  o G |o  o| o  o
                FG    ------
                    F  o  o  o  o
                       ____
                    E |o  o| o  o
                      ------
        ROWS        D  o  o  o  o
                       _     _
                    C |o| o |o| o
                      | | _ | | _
                    B |o||o||o||o|
                      ---| |---| |
                    A  o |o| o |o|
                         ---   ---
                       4  3  2  1
                        COLUMNS
