[40m[2J[4C[0;1;33;42mĿ[2H[4CThe Hardware Parameters Commands are of two types.  The p parameters  [3H[4Care set by enter p followed by the number or letter of the pa[40m[s
[u[42mrameter, [4H[4Cfollowed by the numeric value.  Few systems will require any changes  [5H[4Cfrom the default values.  The remainder of the hardware configuration [6H[4Ccommands are straight forward.  The most commonly used ones [40m[s
[u[42mare listed[7H[4Cbelow.  Remember that they must be entered as shown, with a space     [8H[4Cbetween them.                                                         [9H[4C[40m[s
[u[42m[10H[11H[5C[36;40mSection 2.-  Hardware Parameters Commands.[12H[13H[9C[31mport # - sets comm port to # number[14H[15H[9Cspeed #### -  Sets baud rate to #### number[16H[17H[9Chandshake on -  Enables CTS flow control
[18H[19H[9Chandshake both-  Allows DSZ to use either CTS or Xon/Xoff[20H[26Cflow control.[21H[0m
