    Ŀ
    The Hardware Parameters Commands are of two types.  The p parameters  
    are set by enter p followed by the number or letter of the parameter, 
    followed by the numeric value.  Few systems will require any changes  
    from the default values.  The remainder of the hardware configuration 
    commands are straight forward.  The most commonly used ones are listed
    below.  Remember that they must be entered as shown, with a space     
    between them.                                                         
    

     Section 2.-  Hardware Parameters Commands.

         port # - sets comm port to # number

         speed #### -  Sets baud rate to #### number

         handshake on -  Enables CTS flow control

         handshake both-  Allows DSZ to use either CTS or Xon/Xoff
                          flow control.
